These 3/16" thick aluminum plates are for mounting additional accessories, such as a Hi-Lift jack, recovery treads, etc. These plates can be used on any cargo system or tower assembly. Not for use on RecRac Cargo Baskets. Contains:  (1) pair of plates, (8) V-Blocks...

This kit is used to mount the RecRac Cargo Basket to OEM or aftermarket crossbars. Contains:  (4) Brackets and hardware Note:  If you purchased a RecRac System and later want to run a tent on top of the towers, these brackets allow you to...

This kit is used to mount the RecRac Cargo Basket to RecRac Crossbars. Contains:  (4) Brackets and hardware. Note:  If you previously purchased a RecRac Cargo Basket by itself for your OEM or aftermarket crossbars and later purchase a RecRac Tower Assembly, then these...

These glass-filled nylon blocks and tie-down rings can be used in any V-rail location on the cargo basket or towers for bungie cords and straps. Feature:  An over-molded ¼-20 stainless steel nut in the block and a ¼-20 x 5/8” stainless steel over-molded screw...

These clamps are required for most truck beds to mount the towers. If the top rail of your truck bed has a lip and an area for the clamp bolts to grab behind it, you will use these mounting clamps. (Most trucks beds are...

These clamps are required to mount the towers for Toyota trucks that have the internal bed rail option. Contains:  (4) tower clamps, (8) bolts, washers and Toyota specific T-Nuts.

These fasteners are required to mount the towers if you have a bed rail or a tonneau cover from (Pace Edwards, Rugged Ridge, TruXedo, or the Hyundai Santa Cruz) that has T-slots. Contains:  (8) each carriage bolts, nuts and washers.

These glass-filled nylon blocks can be used in any V-rail location on the cargo basket or towers for mounting additional accessories. Feature:  An over-molded ¼-20 stainless steel nut and include a ¼-20 x ¾” button head cap screw. Maximum load each block:  25 lbs.